Points needing attention when using assembly line equipment
CLICKS：728
Assembly line equipment malfunction, sometimes known as assembly line equipment failure will affect the production, the company quickly contact the manufacturer for repair, maintenance personnel, such as back, according to their reflection, is operator does not operate according to the correct way to use the equipment, not done anything to equipment maintenance, etc. Some possible problems. In order to avoid production line problems, we ask equipment manufacturers for guidance and training on the use and maintenance of equipment. The correct and reasonable use of assembly line equipment can not only avoid the occurrence of accidents, but also reduce the workload of maintenance, improve operation efficiency and service life.
Attention should be paid to the following items when using assembly line equipment:
1. Before using the equipment, check whether the power supply line of the workshop meets the load requirements required by the equipment; Check whether the power supply voltage and frequency comply with equipment requirements.
2. Check the connected part of each wire regularly to see whether the connection is reliable and good, and whether there are rust spots and other phenomena.
3. Check regularly whether the assembly of all parts is good, whether the fasteners are loose, and whether there are other foreign bodies in the body.
4. Before starting the motor, check whether the reducer in the main drive system has been refueled; If not, add no. 30 oil or gear oil above the marked line, clean and change the oil after 200 hours of use, and clean and change the oil every 2000 hours after use.
5, conveyor belt to timely adjust: online at the end of the body has to adjust the screw in the tensioning device, tightness of the conveyor belt has been adjusted during installation, operation after a certain period of time, due to long time to pull the working status of the moving parts of wear and tear, will generate elongation phenomenon, then turn adjusting screw, can achieve tensioning, but should pay attention to tight pine is appropriate.
6. After each shift is finished, the sundries under the line body and the main and secondary machines should be cleaned to keep the equipment clean and tidy and dry to improve the service life of the equipment.
7. During use, components should be placed in place, and non-assembly items such as paper scraps, cloth pieces and tools are strictly prohibited to go online to ensure the safety and reliability of production line operation.
8, every use of one year to check and clean the bearing, bearing seat, if found damaged should not be used, should be repaired or replaced immediately, and add grease, grease amount is about two-thirds of the inner cavity.
